All Prices Exclude P&P Terms & Conditions

XTE2005 Clone ADSL Faceplate for NTE5 Socket

You can see what is inside the faceplate by hovering over the images above. Installation & General Info In Our Support Forums

This faceplate gives you the same benefits as the NTE5/BT Broadband Accelerator bell wire filter with the ADDITION of ADSL filtering!

The XTE-2005 clone faceplate replaces the lower half of a BT NTE5 master socket.

The XTE2005 clone ADSL faceplate can be installed to a BT NTE5 (& also CTE5) socket (also available-see below), supplied with cable tie & screws. The faceplate provides an ADSL modem/router outlet and a standard BT filtered telephone outlet*. IDC connectors on the rear provide FILTERED AND UNFILTERED (ADSL) extensions, ie, you only need this faceplate and not a microfilter at each extension! IDC tool required ONLY if fitting extension wiring. Run an UNFILTERED ADSL extension off the front or rear using a BT NTE2000 extension kit for example. (also available, see below)

*The faceplate features a standard BT socket for telephone connection and an RJ45 socket for ADSL connection-the RJ45 socket will accept both RJ45 AND RJ11 (as featured on most ADSL modems/routers) plugs.

·   Electronically isolates the high speed DSL data stream from the voice band
·   Easy installation; Tidy solution
·   Replaces phone socket(lower half) portion of NTE5 master plate
·   IDC termination to extension socket(s)
·   BT SIN346 compliant, Fully compatible with ADSL, MaxDSL, ADSL 2 and ADSL 2+

Click Here to view installation instructions.

Sorry, this item is discontinued, alternatives listed below.